BAD IGNITION SWITCH HOW TO
BAD IGNITION SWITCH PROFESSIONAL

🚗 Method 4: Replacing the Ignition Switch Use this method only in emergencies and as a last resort. It is also illegal in many jurisdictions. Warning: Hotwiring a car is potentially dangerous and may cause damage to your vehicle’s electrical system.

Strip the insulation from the starter wire and touch it to the twisted battery and ignition wires.

Twist the exposed ends of the battery and ignition wires, which should turn on your car’s electrical system.

Strip about 1 inch of insulation from the battery and ignition wires.

Identify the battery, ignition, and starter wires, usually red, yellow, and green or blue.

Locate the wiring harness connector under the steering column.

Precaution: Always follow the manufacturer’s guidelines for jumpstarting your specific vehicle model. If successful, let it run for several minutes before disconnecting the jumper cables in reverse order.

Start the working vehicle and let it run for a few minutes.

Connect the other end of the black cable to an unpainted metal surface on your car’s engine block, away from the battery.

Connect one end of the black (negative) jumper cable to the working battery’s negative terminal.

Connect the red cable’s other end to the dead battery’s positive terminal.

Connect one end of the red (positive) jumper cable to the positive terminal of the working battery.

Turn off both vehicles and ensure they are in “Park” or “Neutral” with the parking brakes engaged.

Position another vehicle with a working battery close to your car but not touching.

Use this method only in emergencies and as a temporary solution. Warning: This method may cause damage to the ignition switch, and it is illegal to operate a vehicle without a proper key.

Turn the screwdriver clockwise, simulating the action of turning a key.

Insert a flathead screwdriver into the keyhole and gently wiggle it around to engage the ignition switch.

Locate the ignition switch, which is typically situated behind the steering wheel.

First, ensure your car is in “Park” or “Neutral” and the parking brake is engaged.

🚗 Method 1: Use a Screwdriver to Turn the Ignition Switch

BAD IGNITION SWITCH PROFESSIONAL

Safety comes first, so exercise caution and seek professional help if you are unsure about attempting any of these methods. Here I will guide you through several alternative car starting methods, even with a faulty ignition switch.

BAD IGNITION SWITCH HOW TO

How to start a car with a bad ignition switch? Does a new ignition switch require a new key?.How easy is it to fix an ignition switch?.How can you tell if ignition switch is bad?.🚗Method 4: Replacing the Ignition Switch.🚗 Method 1: Use a Screwdriver to Turn the Ignition Switch.how to start a car with a bad ignition switch?.

Bad ignition switch